SiENBE12-713 Instruction
System Configuration 167
FTXG 25/35 E, CTXG 50 E
CAUTION
2.1.15 Care and Cleaning
CAUTION
Before cleaning, be sure to stop the operation and turn the breaker OFF.
Always shut down the unit (and close the panel) before doing any work. Opening the
panel during operation may cause the panel to fall off.
UNITS
"
Indoor unit, Outdoor unit and Remote control
1.Wipe them with dry soft cloth.
"
Front panel
1. Open the front panel.
• Press the two places on the left and right of the
front panel.
2. Remove the front panel.
• With the front panel open so that it is almost
horizontal, slide it to the right.
The revolving axis on the left will come off.
The revolving axis on the right can be removed
by sliding the front panel to the left.
3. Clean the front panel
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
• In case of washing the front panel dry it with
cloth, dry it up in the shade afterwashing.
4. Attach the front panel.
• Place the revolving axes on either side of the
front panel into the holes an slowly close.
(Press either side of the front panel.)
• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
• When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
• When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
• For cleaning, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing compound,
scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely fixed.
To Next Page
Loading...
