Instruction SiENBE12-713
138 System Configuration
Notes on flaps and louvers angles
"
To start COMFORT AIRFLOW operation
5. Press “COMFORT AIRFLOW button”.
• The flap orientation will change, preventing air from blowing directly on the occupants of the room.
• “ ” is displayed on LCD.
<COOL/DRY> The flap will go up.
<HEAT> The flap will go down.
"
To cancel COMFORT AIRFLOW operation
1. Press “COMFORT AIRFLOW button” again.
• The flaps will return to the memory position from before COMFORT AIRFLOW mode.
• “ ” disappears from the LCD.
• When “
SWING button
” is selected, the flaps swinging range
depends on the operation mode. (See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates cold air, which tends to
collected at the bottom of the room, and hot air, which tends to collect
near the ceiling, throughout the room, preventing areas of cold and hot
developing.
Three-Dimensional (3-D) Airflow
• The air flow set automatically.
• The air direction is as shown in the figure at right.
"
ATTENTION
• Always use a remote control to adjust the flaps angle. If you attempt to
move it forcibly with hand when it is swinging, the mechanism may be
broken.
• Always use a remote controller to adjust the louvers angles.
To Next Page
Loading...