SiENBE04-507A Instruction
System Configuration 85
To operate the remote control
• To use the remote control, aim the transmitter at the indoor
unit. If there is anything to block signals between the unit
and the remote control, such as a curtain, the unit will not
operate.
• Do not drop the remote control. Do not get it wet.
• The maximum distance for communication is about 7 m.
To fix the remote control holder on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the holder to a wall, a pillar, or similar location with
the screws procured locally.
3. Place the remote control in the remote control holder.
ATTENTION
Receiver
About remote control
• Never expose the remote control to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft
cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as
inverter-type lamps) is in the room. Consult the shop if that is the case.
• If the remote control signals happen to operate another appliance, move that appliance to
somewhere else, or consult the shop.
Set.
z
To remove, pull it upwards.
Remote control
holder
To Next Page
Loading...