Daikin FTKS35GVMA - Timer Functions; ON Timer Operation; Combining ON and OFF Timers

21
■ To use ON TIMER operation
• Check that the clock is correct. If not, set
the clock to the present time
(page 9.).
1. Press “ON TIMER button”.
is displayed.
blinks.
2. Press “TIMER Setting button”
until the time setting reaches
the point you like.
• Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either but-
ton changes the setting rapidly.
3. Press “ON TIMER button”
again.
•
The TIMER lamp lights up.
■ To cancel ON TIMER
operation
4. Press “CANCEL button”.
•
The TIMER lamp goes off.
■ To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
■
In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote controller.
TEMP
ON/OFF
POWERFUL
MODE
FAN
SWING
SENSOR
ECONO
MOLD PROOF
TIMER
ON CANCEL
OFF
QUIET
2
1, 3
4


   
  
    
   ! 
"#$
01_EN_3P232468-7.fm Page 21 Wednesday, June 4, 2008 10:20 AM