SiENBE12-713 Instruction
System Configuration 205
2.2.12 Care and cleaning
CAUTION
CAUTION
Before cleaning, be sure to stop the operation and turn the breaker OFF.
UNITS
"
Indoor unit, Outdoor unit and Remote control
1. Wipe them with dry soft cloth.
"
Front panel
1. Open the front panel.
• Slide the two stoppers on the left and right
sides inward until they click.
2. Remove the front panel.
• Remove the string.
• Allowing the front panel to fall forward will
enable you to remove it.
3. Clean the front panel.
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
• In case of washing the panel with water, dry
it with cloth, dry it up in the shade after
washing.
4. Attach the front panel.
• Insert the front panel into the grooves of the
unit (3 places).
• Attach the string to the right, inner-side of the
front grille.
• Close the panel slowly.
• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
• When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
• When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
• For cleaning, do not use hot water above 40 °C, benzine, gasoline, thinner, nor other volatile oils, polishing compound,
scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely fixed.
String
String
Place front
panel in
grooves.
To Next Page
Loading...
