Daikin FTKS85JVMG9 - Page 9

Si041352ED Electrical Box
Removal Procedure 7
4 Pull out the indoor heat
exchanger thermistor.

The position of the indoor
heat exchanger thermistor
varies depending on the
model.

Some models have a clamp
fixing the indoor heat
exchanger thermistor to the
indoor heat exchanger.
Cut the clamp, if any.

Be careful not to lose the clip
of the thermistor.
5
6
Remove the screw, and
then the wire fixture.
Remove the 4 screws
on the terminal strip
and disconnect the
connecting wire.
7 Disconnect the
connector [S1] and
release the harness
from the hook.
[S1]: fan motor
For U.S. models

When reassembling, make
sure that the connecting wire
is passed through the
conduit hole at the bottom of
the unit
8 Release the ferrite core.
Step Procedure Points
1
2
3
Indoor heat exchanger thermistor
(R22045)
(R22132)
Clamp
Clip
(R11268)
1
2
3
Terminal strip
Wire
fixture
Connecting wire
(R24478)
1
2
3
(R18716)
[S1] Hook
Lock nut
Back
Conduit
Conduit mounting
plate
(R24421)
(R9501)
Ferrite core