What to do if Daikin Air Conditioner does not operate and OPERATION lamp is off?
If your Daikin Air Conditioner isn't working and the OPERATION lamp is off, check a few things: first, see if a breaker has tripped or a fuse has blown. Next, verify whether there's a power failure in your area. Also, make sure that batteries are correctly installed in the remote controller, and confirm that the timer setting is accurate.
What to do if Daikin FTKS50FV1B operation stops suddenly and OPERATION lamp flashes?
If your Daikin Air Conditioner stops suddenly and the OPERATION lamp is flashing, check if the air filters are clean and whether anything is blocking the air inlet or outlet of the indoor and outdoor units. Clean the air filters or remove any obstacles, then turn the breaker OFF. Also, ensure that the operation modes are the same for all indoor units connected to the outdoor units in the multi system.
General| Cooling Capacity | 5.0 kW |
|---|---|
| Energy Efficiency Ratio (EER) | 3.21 |
| Energy Efficiency Ratio (Cooling) | 3.21 |
| Type | Split Air Conditioner |
| Refrigerant | R410A |
| Power Supply | 220-240V / 50Hz |
Details critical safety warnings and general cautions for unit operation and handling.
Labels and identifies various parts of the indoor air conditioner unit.
Labels and identifies various parts of the outdoor air conditioner unit.
Labels and identifies buttons and display elements of the remote controller.
Step-by-step guide for inserting batteries into the remote controller.
Instructions on how to use the remote, its range, and mounting.
Procedure for setting the current time on the remote controller.
Explains how to begin, end, and adjust temperature for various operation modes.
Details how to change the fan speed settings for different operation modes.
Instructions for adjusting the flap and louvers for airflow direction.
Explains how to activate and cancel the 3-D airflow feature.
How to activate and deactivate the powerful cooling/heating mode.
Steps to enable and disable the quiet mode for the outdoor unit.
Instructions for using the feature to save preferred settings.
Guide to using the sensor-based energy-saving operation.
How to set the timer to turn the unit off automatically.
How to set the timer to turn the unit on automatically.
Instructions for setting both ON and OFF timers simultaneously.
Guidelines for selecting operation modes in a multi-unit system.
Explains priority rules for operation modes and special functions.
Instructions for cleaning the indoor, outdoor units and remote controller.
Detailed steps for opening, cleaning, and reattaching the front panel.
How to clean and replace standard and photocatalytic air filters.
Covers routine checks and procedures for long idle periods.
Explains common situations that are not actual malfunctions.
Lists checks to perform before calling a repair person.
Lists symptoms that require immediate call to the service shop.
To Next Page
