Need help?Do you have a question about the Daikin FTM09NV2S and is the answer not in the manual?
Open the front panel and pull out the air filter downward.
Unfasten projections and hooks to remove the filter ASSY or filter.
Open the front panel until it stops.
Slide the left rotary shaft to the right to release it.
Remove the right rotary shaft using the same method.
Open horizontal blades, then remove screw covers and screws.
Unfasten the three hooks located on the top of the front grille.
Pull the upper grille out, lift the lower part, and remove the grille.
Unfasten shafts and bend blades to remove horizontal blades.
Unfasten hooks at shaft mounting and upper positions to remove vertical blade ASSYS.
Remove the screw securing the wire fixture.
Remove terminal board screws and disconnect connecting wires.
Disconnect the connector labeled [S6].
Disconnect the connector labeled [S7].
Remove the screw and detach the drip proof plate.
General| Power Supply | 220-240V, 50Hz |
|---|---|
| Weight (Indoor Unit) | 9 kg |
| Star Rating | 3 Star |
| Refrigerant | R32 |
| Indoor Unit Weight | 9 kg |
| Type | Split |
To Next Page
