Why Daikin FTS35BVMB is not turning on? (OPERATION lamp is off)
If your Daikin Air Conditioner isn't turning on and the OPERATION lamp is off, check the following: * Ensure the breaker hasn't been turned OFF or a fuse hasn't blown. * Verify that there isn't a power failure. * Confirm that batteries are correctly installed in the remote controller. * Check if the timer setting is correct.
Why my Daikin Air Conditioner smells bad?
If your Daikin Air Conditioner's indoor unit is emitting an odor, it's likely due to smells from the room, furniture, or cigarettes being absorbed into the unit and discharged with the airflow. If this occurs, it is recommended to have the indoor unit cleaned by a technician.
How to improve cooling (heating) effect of Daikin FTS35BVMB?
If you're experiencing poor cooling or heating with your Daikin Air Conditioner, consider these points: * Ensure the air filters are clean. * Make sure nothing is blocking the air inlet or outlet of the indoor and outdoor units. * Verify that the temperature setting is appropriate. * Confirm that windows and doors are closed. * Check if the airflow rate and direction are set correctly. * Check if the unit is set to the INTELLIGENT EYE mode.
What to do if there are water leaks from the indoor unit of my Daikin FTS35BVMB Air Conditioner?
If water leaks from the indoor unit of your Daikin air conditioner, turn the breaker OFF and call the service shop.
What to do if my Daikin FTS35BVMB operation stops suddenly and the OPERATION lamp flashes?
If your Daikin Air Conditioner stops suddenly and the OPERATION lamp flashes, clean the air filters or remove any obstacles. Then, turn the breaker OFF, turn it back ON, and try operating the air conditioner with the remote controller.
Why is my Daikin FTS35BVMB Air Conditioner cooling or heating effect poor?
The cooling or heating effect may be poor because the air filters are not clean, there's something blocking the air inlet or outlet of the indoor and outdoor units, the temperature setting is inappropriate, the windows and doors are not closed, the airflow rate and direction are not set appropriately, or the unit is set to INTELLIGENT EYE mode. Please, check these settings.
Why Daikin Air Conditioner outdoor unit emits water or steam?
The outdoor unit of your Daikin Air Conditioner may emit water or steam. This can occur in HEAT mode when frost on the outdoor unit melts during defrost operation. In COOL or DRY mode, moisture in the air can condense on the cool surface of the outdoor unit piping and drip.
Why Daikin Air Conditioner operation does not start soon?
If your Daikin Air Conditioner doesn't start immediately after pressing the ON/OFF button soon after stopping or reselecting the mode, wait for about 3 minutes.
What to do if Daikin FTS35BVMB operation stops suddenly? (OPERATION lamp is on)
If your Daikin Air Conditioner stops suddenly and the OPERATION lamp is on, it might be due to a sudden large voltage fluctuation. For system protection, the air conditioner automatically resumes operation in about 3 minutes.
General| Cooling Capacity | 3.5 kW |
|---|---|
| Indoor Unit Dimensions (W x H x D) | 815 x 280 x 223 mm |
| Outdoor Unit Dimensions (W x H x D) | 658 x 550 x 275 mm |
| Weight (Indoor Unit) | 9 kg |
| Cooling Capacity (W) | 3500 W |
| Indoor Unit Weight | 9 kg |
| Refrigerant | R32 |
| Type | Split |
| Power Supply | 230V, 50Hz, Single Phase |
Details critical warnings and cautions for safe operation of the air conditioner.
Identifies and labels components of the indoor and outdoor units, and the remote controller.
Instructions for initial setup, including battery installation, clock setting, and remote controller operation.
Guides on starting, stopping, and changing temperature settings for various operation modes.
Instructions for adjusting horizontal flaps and vertical louvers for optimal air flow.
How to activate and cancel the powerful mode for quick cooling or heating effects.
Function to record and recall preferred temperature and air flow settings for convenience.
Utilizes an infrared sensor to detect human movement for energy-saving or normal operation.
Procedures for setting OFF TIMER and ON TIMER for automatic unit control.
Instructions for cleaning the indoor unit, outdoor unit, remote controller, and air filters.
Addresses common cases that are not actual troubles but require understanding.
Lists abnormality codes displayed on the remote controller and their meanings.
To Next Page
