10
Installation Guideline
Indoor Installation Guideline
1. Installing The Mounting Plate
Recommended mounting plate retention spots and dimensions
The mounting plate should be installed
on a wall which can support the weight
of the indoor unit
Mounting plate fixing screw
Mounting plate
• The mounting plate should be installed on a wall which can support the weight of the indoor unit.
1) Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and
mark the boring points on the wall.
2) Secure the mounting plate to the wall with screws.
All dimensions are in mm
Indoor Unit FTV28/35/50A
Ç Recommended mounting plate
retention spots (7 spots in all)
Place a leveler
on these tabs.
Use a tape measure as shown.
Position the end of the tape
measure at w
Through-the-wall
hole Ø 65mm
Drain hose position
unit : mm
116.5
241.646.4
770
170
49.5
50
49.5170
46.4
241.6
117
Ø 65
Ø 65
To Next Page
Loading...
Need help?
General
