English 5
English
Indoor Unit Installation
1. Installing the mounting plate
• The mounting plate should be installed on a wall which can support the weight of the indoor unit.
1) Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and mark the boring points
on the wall.
2) Secure the mounting plate to the wall with screws.
Recommended mounting plate retention spots and dimensions
770
Place the pipe port cover
in this pocket.
Gas pipe end
Through-the-wall
hole I65
Recommended mounting plate
retention spots (7 spots in all)
Place a leveler
on these tabs.
44.5
44.5
48
337
285
170
48
50
170
116.5
117
337
213
237
Drain hose position
Liquid pipe end
990
unit: mm
Gas pipe end
Through-the-wall
hole I80
44.5
44.5
60
447
435
295
171.5
48
60
171.5
126.5
117
Drain hose position
Liquid pipe end
Use a tape measure
as shown.
Position the end of
the tape measure at .
333
Place a leveler
on these tabs.
Recommended mounting plate
retention spots (7 spots in all)
The removed pipe
port cover can be
kept in the mounting
plate pocket.
Mounting
plate
Removed pipe
port cover
A
To Next Page
Loading...
