What to do if my Daikin FTX50GV1B operation stops suddenly and OPERATION lamp flashes?
If the Daikin Air Conditioner stops suddenly and the OPERATION lamp is flashing, clean the air filters or remove any obstructions. Then, turn the breaker OFF, and then turn it back ON. Try operating the air conditioner again using the remote controller.
Why does my Daikin FTX50GV1B outdoor unit emit water or steam?
The outdoor unit of your Daikin Air Conditioner emits water or steam in HEAT mode when the frost on the outdoor unit melts into water or steam during defrost operation.
Why does my Daikin FTX50GV1B Air Conditioner operation stop suddenly and the OPERATION lamp is on?
The Daikin Air Conditioner might stop operating due to a sudden large voltage fluctuation. It will automatically resume operation in about 3 minutes.
Why does mist come out of my Daikin FTX50GV1B Air Conditioner indoor unit?
Mist coming from the indoor unit of your Daikin Air Conditioner happens when the air in the room is cooled into mist by the cold airflow during cooling operation.
What to do if my Daikin FTX50GV1B Air Conditioner indoor unit gives out odour?
If the indoor unit of your Daikin Air Conditioner emits an odor, it is recommended to have the indoor unit cleaned by a technician. Consult the service shop where you bought the air conditioner.
Safety warnings specifically for personnel performing repairs.
Safety advice for end-users of the equipment.
Explains the meaning of various icons used in the manual.
Lists all available functions and their model compatibility.
Detailed performance and physical data for all models.
Wiring details for indoor unit circuit boards and connectors.
Wiring details for outdoor unit circuit boards and connectors.
Explains core operational functions like temperature and frequency control.
Details the role of various thermistors in system operation.
Outlines control modes, frequency, and operational logic.
Explains the remote control buttons and display functions.
Lists common problems and initial check items.
Guides diagnosis based on LED indicators on units.
Describes methods for entering and using diagnostic modes.
Lists error codes and their descriptions for troubleshooting.
Provides procedures for checking specific components like thermistors and motors.
Procedures for refrigerant recovery before relocation or disposal.
Details how to initiate and manage forced cooling mode.
Steps for verifying functions and settings after installation.
Configuration options like unit addresses and facility settings.
Schematic diagrams showing refrigerant piping connections.
Electrical wiring diagrams for indoor and outdoor units.
General| Cooling Capacity | 5.0 kW |
|---|---|
| Heating Capacity | 6.0 kW |
| Energy Efficiency Ratio (EER) | 3.21 |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R410A |
| Energy Efficiency Ratio (Cooling) | 3.21 |
| Type | Split |
To Next Page
