Need help?Do you have a question about the Daikin FTX50KVM and is the answer not in the manual?
General| Brand | Daikin |
|---|---|
| Model | FTX50KVM |
| Category | Air Conditioner |
| Language | English |
Steps to remove air filters by opening the front panel and unfastening hooks.
Instructions to remove titanium apatite air-purifying filters by unfastening hooks.
Steps to remove the front panel by releasing shafts after opening it further.
Procedure to remove the service cover by unscrewing it.
Steps to remove the front grille by unscrewing it and unfastening hooks.
Steps to remove horizontal blades by releasing center and left shafts.
Steps to remove vertical blades by releasing shafts and unfastening hooks.
Steps to remove the electrical box by removing plates, clamps, and wires.
Procedure to remove PCBs by unfastening hooks and disconnecting connectors.
Steps to remove the swing motor for horizontal blades by unscrewing and detaching.
Steps to remove the swing motor for vertical blades by detaching the assembly and motor.
Steps to disconnect refrigerant piping by unscrewing flare nuts for gas and liquid lines.
Procedure to detach the indoor unit from the installation plate.
Steps to remove the indoor heat exchanger by unfastening hooks on the sides.
Steps to remove the right side plate by unscrewing it.
Procedure to remove fan motor and rotor, including fixing plates and side plates.
Instructions to remove the bearing by pushing it inward.
To Next Page
