Daikin FTXF20TVMA - Page 85

20
 Titanium apatite deodorizing lter (sold separately) /
dust collection lter (PM2.5) (sold separately)
Attaching
1. Open the front panel and
pull out the air lters.
Page 19
2. Insert the titanium apatite
deodorizing lters or dust
collection lters (PM2.5).
• Checkthattheltersareinsertedsecurelyunderthetabs.
Filter
Tab
Cleaning and Replacement
1. Open the front panel and
pull out the air lters.
Page 19
2. Take off the titanium apatite
deodorizing lters or dust
collection lters (PM2.5).
•Removetheltersfromthetabs.
Filter
Tab
3. Clean or replace the titanium
apatite deodorizing lters or
dust collection lters (PM2.5).
[Cleaning for titanium apatite
deodorizing lter (Blue-Black)]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15minutes if very dirty.
3-2 After washing, shake off remaining
water and let them dry in the shade.
•Thisltercanberenewedbywashingitwithwater
onceevery 6 monthsandwerecommend
replacingitonceevery 3 years.
•
Donotwiringoutthelterwhenremovingwaterfromit.
[Cleaning for dust collection lter
(PM2.5) (White)]
• Donotwashtheltersasthiswillreducetheirefciency.
• Itisrecommendedtoreplaceitonceevery 6 months.
[Replacement]
Remove each lter from the
front grille by detaching them
from the 6 tabs and then install
the new lters.
•Whenattachingthelter,checkthatthelteris
propertysetinthetabs.
4. Set the lters as they were
and close the front panel.
•Pressthefrontpanelatbothsidesandthecenter.
NOTE
• Operationwithdirtylters:
−cannotdeodorisetheair,
−cannotcleantheair,
−resultsinpoorcooling,
−maycauseodour.
• Disposeofoldltersasnon-ammablewaste.
Care Care
01_EN_3P372379-16N.indd 20 05-Mar-19 3:51:53 PM