8
Preparation Before Operation
■ To operate the remote controller
• To use the remote controller, aim the transmitter at the
indoor unit. If there is anything to block signals
between the unit and the remote controller, such as a
curtain, the unit will not operate.
• Do not drop the remote controller. Do not get it wet.
•
The maximum distance for communication is about 7m.
■ To fix the remote controller holder on the wall
1. Choose a place from where the signals
reach the unit.
2. Fix the holder to a wall, a pillar, or similar
location with the screws procured locally.
3. Place the remote controller in the
remote controller holder.
■ Turn on the power breaker
• Turning on the power breaker will cause the panel and
flap to open once and then close again.
(This is a normal procedure.)
CAUTION
ATTENTION
• During operation (i.e. when the panel is open or being opened or closed), do not touch the
panel with your hands.
■
■■
■
About remote controller
• Never expose the remote controller to direct sunlight.
•
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such
as inverter-type lamps) is in the room. Consult the shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance
to somewhere else, or consult the shop.
Receiver
Remote controller
holder
Set.
●
To remove, pull it upwards.
Panel
Flap
01_EN_3P166462-1.fm Page 8 Tuesday, September 20, 2005 5:08 PM
To Next Page
Loading...
Need help?
General
