To Next PageTo Next PageHow to fix a Daikin FTXG25JV1BW Air Conditioner remote controller that is not working properly?
If the remote controller for your Daikin Air Conditioner isn't working, replace all the batteries with new, size AAA.LR03 (alkaline) batteries.
Why does the HEAT operation of my Daikin Air Conditioner stop suddenly and make a flowing sound?
If the HEAT operation on your Daikin Air Conditioner stops suddenly and you hear a flowing sound, it's likely that the outdoor unit is removing frost. Please wait for about 4 to 12 minutes.
How to fix a Daikin FTXG25JV1BW Air Conditioner when the ON/OFF TIMER does not operate according to the settings?
If the ON/OFF TIMER on your Daikin Air Conditioner isn't working as set, check if the ON/OFF TIMER and the WEEKLY TIMER are set to the same time.
What to do if the multi-colored indicator lamp blinks on my Daikin FTXG25JV1BW?
If the multi-colored indicator lamp on your Daikin Air Conditioner is blinking, it could be due to a protection device being activated in either the indoor or outdoor unit, or a thermistor malfunction. It could also indicate a signal transmission error between the indoor and outdoor units. In both cases, you should conduct the diagnostic procedure described in the following pages.
Why is the cooling/heating effect poor on my Daikin Air Conditioner?
If your Daikin Air Conditioner isn't cooling or heating well, try these steps: * Clean the air filters. * Check for obstructions blocking the air inlet or outlet of both the indoor and outdoor units. * Ensure the temperature setting is appropriate for your needs. * Verify that all windows and doors are completely closed. * Make sure the airflow rate and direction are set correctly.
Why does my Daikin FTXG25JV1BW indoor unit give out an odor?
If your Daikin Air Conditioner's indoor unit is emitting an odor, it's likely due to smells from the room, furniture, or cigarettes being absorbed into the unit and released with the airflow. It is recommended to have the indoor unit professionally cleaned by a technician. Consult the service shop where you bought the air conditioner.
What to do if my Daikin Air Conditioner operation stopped suddenly and the multi-monitor lamp flashes?
If your Daikin Air Conditioner suddenly stops and the multi-monitor lamp flashes, try the following: 1. Clean the air filters. 2. Turn the breaker off, remove any obstacles, and then turn the breaker back on. Try operating the air conditioner with the remote controller. 3. Set all indoor units to the same operation mode and check that the lamps flash. 4. If the operation mode is in AUTO, set all indoor unit operation modes to COOL or HEAT for a moment and check again that the lamps are normal. 5. If the lamp still flashes after these steps, you should call the service shop where you bought the air conditioner.
What to do if an abnormal functioning happens during operation of my Daikin Air Conditioner?
If your Daikin Air Conditioner is malfunctioning during operation, it might be due to lightning or radio waves. Try turning the breaker off, then turning it back on, and try operating the air conditioner with the remote controller.
Why did my Daikin FTXG25JV1BW operation stop suddenly and the multi-monitor lamp is on?
If your Daikin Air Conditioner stops suddenly and the multi-monitor lamp is on, it may be due to a large voltage fluctuation, triggering system protection. The unit will automatically resume operation in about 3 minutes.
What to do if the front panel of my Daikin Air Conditioner does not open and the multi-monitor lamp flashes?
If the front panel of your Daikin Air Conditioner doesn't open and the multi-monitor lamp flashes, check if something is caught in the front panel. If so, remove the object and try operating it again using the remote controller. If the front panel still does not open and the multi-monitor lamp is still flashing, consult the service shop where you bought the air conditioner.
General| Cooling Capacity | 2.5 kW |
|---|---|
| Heating Capacity | 3.2 kW |
| Power Supply | 220-240 V, 50 Hz |
| Indoor Unit Weight | 8 kg |
| Outdoor Unit Weight | 30 kg |
| Refrigerant | R-32 |
| Type | Split System |
| Energy Efficiency Ratio (EER) | 3.84 |
| Seasonal Energy Efficiency Ratio (SEER) | 6.0 |
| Energy Efficiency Ratio (Cooling) | 3.84 |
| Noise Level (Indoor) | 19 dB |
Energy saving via motion detection and personalized scheduling.
Comfort Airflow and Outdoor Unit Quiet features for user experience.
Critical safety guidelines to prevent fire, injury, and property damage.
Identification of main components across the air conditioner system.
Battery installation and holder mounting instructions.
Guide to choosing AUTO, DRY, COOL, HEAT, FAN and starting/stopping.
Setting temperature, energy saving tips, and operating limits.
Controlling airflow direction and fan speed for comfort.
Adjusting airflow direction to prevent direct blowing.
Using the sensor for motion detection and energy saving.
Maximizing cooling/heating performance temporarily.
Reducing outdoor unit noise for neighborhood consideration.
Limiting maximum power consumption for efficient operation.
Scheduling automatic unit shutdown.
Scheduling automatic startup and sequential operation.
Programming daily timers and copying settings.
Checking and temporarily disabling timer schedules.
Removing individual or all programmed timer settings.
Guidelines for multi-unit operation and priority room functions.
Instructions for vacuuming or washing the air filters.
Cleaning filters, panel, and recommendations for periodic professional maintenance.
Addressing common problems with the indoor unit and remote.
Problems with outdoor unit emissions and timer/operation errors.
Explains issues like timer malfunction or mist from indoor unit.
Guidance on critical issues requiring professional assistance and unit disposal.
How to access error codes using the remote controller and their explanations.
Guide to understanding LED lights on the outdoor unit PCB for troubleshooting.
