Why did my Daikin Air Conditioner stop suddenly but the operation lamp is on?
If your Daikin Air Conditioner stops suddenly but the OPERATION lamp is on, it may be due to a sudden large voltage fluctuation for system protection. The unit will automatically resume operation in about 3 minutes.
What to do if my Daikin FTXG35CVMAW Air Conditioner indoor unit is leaking water?
If water leaks from the indoor unit of your Daikin Air Conditioner, turn the breaker OFF and call the service shop.
How to fix a Daikin FTXG35CVMAW Air Conditioner that won't turn on?
If your Daikin Air Conditioner is not operating and the OPERATION lamp is off, check if a breaker is turned OFF or a fuse is blown. Also, verify if there is a power failure, if batteries are set in the remote controller, or if the timer setting is correct.
Why is the cooling/heating effect poor on my Daikin FTXG35CVMAW?
If your Daikin Air Conditioner isn't cooling or heating well, several factors could be the cause. Begin by checking if the air filters are clean. Ensure that nothing is blocking the air inlet or outlet of either the indoor or outdoor units. Verify that the temperature setting is appropriate for your needs, and that all windows and doors are properly closed. Confirm that the airflow rate and direction are correctly set. Lastly, check if the unit is set to INTELLIGENT EYE mode, as this mode might be affecting the cooling or heating performance.
What to do if my Daikin FTXG35CVMAW stops suddenly and the operation lamp flashes?
If your Daikin Air Conditioner suddenly stops and the OPERATION lamp is flashing, try these steps: Begin by cleaning the air filters to remove any accumulated dust or debris. Make sure there are no obstructions blocking the unit. After addressing these issues, turn the breaker OFF, wait a moment, and then turn it back ON. Finally, attempt to operate the air conditioner again using the remote controller.
What to do if a button on my Daikin Air Conditioner remote is not working?
If a switch or a button on your Daikin Air Conditioner often fails to work properly, turn the breaker OFF and call the service shop.
What to do if my Daikin FTXG35CVMAW does not operate and the operation lamp is off?
If your Daikin Air Conditioner isn't turning on and the OPERATION lamp is off, check the following: First, see if a breaker has tripped or a fuse has blown. Next, verify that there isn't a power failure in your area. Ensure that the batteries in the remote controller are correctly installed and have power. Finally, double-check that the timer setting is correct and hasn't inadvertently turned the unit off.
What to do if Daikin FTXG35CVMAW shows abnormal functioning during operation?
If your Daikin Air Conditioner is showing abnormal behavior during operation, turn the breaker OFF, wait a few seconds, and then turn it back ON. After doing this, try operating the air conditioner again using the remote controller to see if the issue has been resolved.
Why doesn't hot air flow out immediately from my Daikin FTXG35CVMAW Air Conditioner after starting heating?
If hot air doesn't flow out soon after starting the heating operation on your Daikin Air Conditioner, allow 1 to 4 minutes for the unit to begin heating.
How to get rid of bad smell from my Daikin FTXG35CVMAW?
If the indoor unit of your Daikin Air Conditioner gives out an odor, it is recommended to have the indoor unit washed by a technician.
General| Brand | Daikin |
|---|---|
| Model | FTXG35CVMAW |
| Category | Air Conditioner |
| Language | English |
Covers warnings and cautions for operation, fire, injury, and handling.
Guidelines for selecting installation locations to avoid annoying neighbours with noise.
Identifies and describes parts of the indoor air conditioning unit.
Explains the buttons and display of the remote control unit.
Instructions for inserting and replacing batteries in the remote controller.
Provides advice on optimizing energy consumption for cooling and heating.
Important points regarding power consumption and long-term usage.
Details how to start, stop, and adjust the temperature for different operation modes.
Provides notes for HEAT, DRY, and AUTO operations, and airflow settings.
Instructions for adjusting the flap (horizontal) and louvers (vertical) for airflow.
Explains how to activate and deactivate the powerful cooling/heating mode.
Details how to enable and disable the silent operation for the outdoor unit.
Instructions for activating and deactivating the sensor-based operation mode.
Step-by-step guide to setting the timer to turn the unit off.
Detailed steps for safely removing and cleaning the front panel of the indoor unit.
Guidance on washing air filters and maintaining the photocatalytic air-purifying filter.
Covers general checks, filter cleaning, and preparing the unit for long periods of inactivity.
Addresses issues like delayed start, no hot air, and sudden heating stops.
Lists symptoms that require immediate professional service.
Information on proper unit disposal and the recommendation for periodic professional maintenance.
To Next Page
