Daikin FTXN09NMVJU - Titanium Apatite Filter Maintenance (Models FTX09;12)

21
Care
 Titanium apatite photocatalytic air-purifying  lter
1. Open the front panel and
pull out the air  lters.
Page 20
2. Take off the titanium apatite
photocatalytic air-purifying
 lters.
• Remove the  lters from the tabs.
3. Clean or replace the
titanium apatite
photocatalytic air-purifying
 lters.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15minutes if very dirty.
3-2 After washing, shake off remaining
water and let them dry in the shade�
• Do not wring out the  lter to remove water from it.
[Replacement]
Remove the  lter from the tabs
and prepare a new one�
• Dispose of the old  lter as non- ammable waste.
4. Insert the titanium apatite
photocatalytic air-purifying
 lters as they were.
• When attaching the  lter, check that the  lter is
properly set in the tabs.
5. Reattach the  lters.
Page 20
6. Close the front panel slowly�
Page 20
NOTE
• Operation with dirty  lters:
− cannot deodorize the air,
− cannot clean the air,
− results in poor heating or cooling,
− may cause odor.
• Dispose of old  lters as non- ammable waste.
• To order a titanium apatite photocatalytic air-purifying  lter, contact
the dealer where you bought the air conditioner.
Item
Titanium apatite photocatalytic
air-purifying  lter 1set
Part No� KAF970A46 (without frame)
Care and Cleaning
FTX09NMVJU / FTX12NMVJU / FTXN09NMVJU / FTXN12NMVJU
01_EN_3P379751-4C.indd 21 11/6/2015 16:14:47