24
Care
Titanium apatite photocatalytic air-purifying lter
1. Open the front panel and
pull out the air lters.
Page 23
2. Take off the titanium apatite
photocatalytic air-purifying
lters.
• Hold the recessed parts of the frame and unhook
the 4claws.
ClawClaw
3. Clean or replace the
titanium apatite
photocatalytic air-purifying
lters.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15minutes if very dirty.
• Do not remove the lter from the frame when
washing with water.
3-2 After washing, shake off remaining
water and let them dry in the shade�
• Do not wring out the lter to remove water from it.
[Replacement]
Remove the lter from the lter
frame and prepare a new one�
• Do not throw away the lter frame. Reuse the lter
frame when replacing the titanium apatite
photocatalytic air-purifying lter.
• Dispose of the old lter as non- ammable waste.
4. Insert the titanium apatite
photocatalytic air-purifying
lters as they were.
• When attaching the lter, check that the lter is
properly set in the tabs.
5. Reattach the lters.
Page 23
6. Close the front panel slowly�
Page 23
NOTE
• Operation with dirty lters:
− cannot deodorize the air,
− cannot clean the air,
− results in poor heating or cooling,
− may cause odor.
• Dispose of old lters as non- ammable waste.
• To order a titanium apatite photocatalytic air-purifying lter, contact
the dealer where you bought the air conditioner.
Item
Titanium apatite photocatalytic
air-purifying lter 1set
Part No�
KAF970A46 (without frame)
KAF970A45 (with frame)*
*Users of FTXN18/24NMVJU, please purchase KAF970A45
(with frame) when purchasing the lter for the rst time.
01_EN_3P379751-4C.indd 24 11/6/2015 16:14:52