Daikin FTXN12NMVJU - Preparation Before Operation; Inserting Batteries; Mounting Remote Controller Holder; Fahrenheit;Celsius Display Switch

Si041552E PCBs / Swing Motor
Removal Procedure 9
5. PCBs / Swing Motor
Warning

Be sure to wait for 10 minutes or more after turning off all power supplies before
disassembling work.
Step Procedure Points
1. Remove the control PCB.

When reassembling, fit the
projection at the back of the
terminal board into the hole
on the mounting plate.
1 Remove the screw of
the terminal board.
2 Release the earth /
ground wires and the
thermistor harness from
the slit.
3 Release the terminal
board harness from the
groove and the 3
hooks.
Terminal board
(R21839)
Mounting plate
Projection
(R21840)
Slit
Thermistor harness
Earth /
ground
wire
(R21841)
Hook
Groove
Terminal board harness
(R21842)