17
English
ON TIMER Operation
To use ON TIMER operation
Press 1. .
“ ” is displayed on the LCD.
Each pressing of advances the time setting by 1 hour.
The time can be set between 1 to 12 hours.
The TIMER lamp lights up.•
To cancel ON TIMER operation
Press 2. .
“ • ” disappears from the LCD.
The TIMER lamp goes off.•
To combine ON TIMER and OFF TIMER
A sample setting for combining the 2 timers is shown below.•
“ •
” and “ ” are displayed on the LCD.
Display
NOTE
In the following cases, set the timer again.
After a breaker has turned off.•
After a power failure.•
After replacing batteries in the remote controller.•
01_EN_3P272441-5.indb 1701_EN_3P272441-5.indb 17 11/30/2010 4:01:52 PM11/30/2010 4:01:52 PM
To Next Page
Loading...
