20
Care and Cleaning
Titanium apatite photocatalytic air-purifying fi lter 3-2
The titanium apatite photocatalytic air-purifying fi lter can be renewed by washing it with
water once every 6 months. We recommend replacing it once every 3 years.
[Maintenance]
Vacuum dusts, and soak in warm water 3-2-1
or water for about 10 to 15 minutes if dirt
is heavy.
Do not remove the fi lter from frame when •
washing with water.
After washing, shake off remaining water 3-2-2
and dry in the shade.
Since the material is made out of •
polyester, do not wring out the fi lter when
removing water from it.
[Replacement]
Remove the tabs on the fi lter frame and 3-2-3
replace with a new fi lter.
Do not throw away the fi lter frame. Reuse •
the fi lter frame when replacing the
titanium apatite photocatalytic air-
purifying fi lter.
Dispose of the old fi lter as non-fl ammable •
waste.
Set the air fi lter and titanium apatite 4.
photocatalytic air-purifying fi lter as they
were and close the front panel.
Insert claws of the fi lters into slots of the front panel. •
Close the front panel slowly and push the panel at
the 3 points. (One on each side and one in the
middle.)
NOTE
Operation with dirty fi lters: •
cannot deodorise the air.(1) cannot clean the air.(2)
results in poor heating or cooling.(3) may cause odour.(4)
To order titanium apatite photocatalytic air-purifying fi lter contact to the service shop there you •
bought the air conditioner.
Dispose of the old fi lter as non-fl ammable waste. •
Item Part No.
Titanium apatite photocatalytic air-purifying fi lter
(without frame) 1 set
KAF970A46
01_EN_3P272441-5.indb 2001_EN_3P272441-5.indb 20 11/30/2010 4:01:56 PM11/30/2010 4:01:56 PM
To Next Page
Loading...
Need help?
General
