23
English
The outdoor unit emits water or
steam.
In HEAT operation
The frost on the outdoor unit melts into water •
or steam when the air conditioner is in
defrost operation.
In COOL or DRY operation
Moisture in the air condenses into water on •
the cool surface of outdoor unit piping and
drips.
The air conditioner does not
operate.
(OPERATION lamp is off.)
Hasn’t a breaker turned off or a fuse blown?
•
Isn’t it a power failure?
•
Are batteries set in the remote controller?
•
Is the timer setting correct?
•
Hot air does not fl ow out soon
after the start of HEAT operation.
The air conditioner is warming up. •
You should wait for 1 to 4 minutes.
(The system is designed to start discharging
air only after it has reached a certain
temperature.)
Operation stopped suddenly.
(OPERATION lamp fl ashes.)
Are the air fi lters clean? •
Clean the air fi lters.
Is there anything to block the air inlet or the •
outlet of the indoor and the outdoor units?
Turn the breaker off and take all obstacles •
away. Then turn it on again and try operating
the air conditioner with the remote controller.
If the lamp still fl ashes, call the service shop
where you bought the air conditioner.
Operation stopped suddenly.
(OPERATION lamp is on.)
For system protection, the air conditioner •
may stop operating on a sudden large
voltage fl uctuation. It automatically resumes
operation in about 3 minutes.
Mist comes out of the indoor unit.
This happens when the air in the room is •
cooled into mist by the cold airfl ow during
COOL operation.
This is because the air in the room is cooled •
by the heat exchanger and becomes mist
during defrosting operation.
01_EN_3P272441-5.indb 2301_EN_3P272441-5.indb 23 11/30/2010 4:01:59 PM11/30/2010 4:01:59 PM
To Next Page
Loading...
Need help?
General
