SiBE04-624 Instruction
System Configuration 119
3.11 SET UP
14
SET UP
Sets the unit operation and remote controller display according to your preference.
1. Hold “ ”
for about 2 seconds.
•
The setup mode will be activated.
2. The item will change every time “ ” is pressed.
3.
The settings will change every time “ ” is pressed respectively.
•
Direct the remote controller toward the main unit to make settings.
1, 2
3
Item Setting Description
is default.
CHILD PROOF LOCK
ON/OFF
MOLD PROOF
ON/OFF
MONITOR BRIGHTNESS
BEEP volume
CONTRAST Setting
Setting complete
:The display on the remote control goes back to normal if no setting is
made for 10 seconds.
•
Restricts the remote controller operations
to avoid misuse by children. (See NOTE.)
•
If the unit is set to “MOLD PROOF ON”, it
may automatically enter MOLD PROOF
operation mode after operating in DRYING,
DRY COOLING or COOLING operation
mode, depending on the amount of time it
had been operating. This is to dry out the
interior of the air conditioner. (page 15.)
•
Changes the brightness of the indoor unit
display.
•
Sets the receiving tone volume.
•
Sets the grayscale for the remote controller
LCD.
•
Selectable from contrast 1 to 16.
OFF ON
OFF ON
HIGH
LOW OFF
LOW
HIGH
OFF
1616
NOTE
Note on CHILD PROOF LOCK
•
Selecting “ON” while CHILD PROOF LOCK setting and then pressing “ ” or making no setting for 10 seconds will cause the CHILD
PROOF LOCK to be enabled and the display to show “ ”.
•
The button operations other than “ ” are disabled in CHILD PROOF LOCK mode.
•
To cancel the CHILD PROOF LOCK, set to “OFF” following the above steps from 1 to 3.
To Next Page
Loading...
Need help?
General
