Instruction SiENBE12-713
132 System Configuration
Notes on COMFORT AIRFLOW operation
Notes on flaps and louvres angles
"
To start COMFORT AIRFLOW operation
1. Press “COMFORT AIRFLOW button”.
• The flap position will change, preventing air from blowing directly on the occupants of the room.
• “ ” is displayed on the LCD.
(COOL/DRY) The flap will go up.
(HEAT) The flap will go down.
"
To cancel the COMFORT AIRFLOW operation
2. Press “COMFORT AIRFLOW button” again.
• The flaps will return to the memory position from before COMFORT AIRFLOW mode.
• “ ” disappears from the LCD.
• POWERFUL operation and COMFORT AIRFLOW operation cannot be used at the same time. Priority is given to
POWERFUL operation.
• When “
SWING button
” is selected, the flaps swinging range depends
on the operation mode. (See the figure.)
"
ATTENTION
• Always use a remote control to adjust the flaps angle. If you attempt to
move it forcibly with hand when it is swinging, the mechanism may be
broken.
• Be careful when adjusting the louvres. Inside the air outlet, a fan is
rotating at a high speed.
To Next Page
Loading...
