Instruction SiENBE12-713
140 System Configuration
Notes on flap and louvers angles.
"
To adjust the vertical blades (louvers)
• When adjusting the louver, use a robust and
stable stool and watch your steps carefully.
Hold the knob and move the louvers.
(You will find a knob on the left side and the
right side blades.)
• Unless [SWING] is selected, you should set the flap at a near-
horizontal angle in COOL or DRY mode to obtain the best
performance.
• In COOL or DRY mode, if the flap is fixed at a downward position, the
flap automatically moves in about 60 minutes to prevent condensation
on it.
"
ATTENTION
• Always use a remote control to adjust the flap angle. If you attempt to
move it forcibly with hand when it is swinging, the mechanism may be
broken.
• Be careful when adjusting the louvers. Inside the air outlet, a fan is
rotating at a high speed.
DRY
COOL
HEAT
HEAT
To Next Page
Loading...
