EasyManua.ls Logo

Daikin FTXS20K2V1B - Preparation before Operation; To set the batteries

Daikin FTXS20K2V1B
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
English 6
•Removethepipeportcoverasshownbelow.
1)Cutoffthepipeportcoverfrominsidethefrontgrilleusingacopping
saw.
Applythebladeofthecoppingsawtothenotch,andcutoffthepipe
portcoveralongtheslit.
2)Aftercuttingoffthepipeportcover,performling.Removetheburrs
alongthecutsectionusingahalfroundneedlele.
CAUTION
•Ifthepipeportcoveriscutoffusingnippers,thefrontgrillewillbedamaged.Pleasedonotusenippers.
•Wearglovesduringthepipeportcoverremoval.
3-1. Right-side, right-back, or right-bottom piping
1)Attachthedrainhosetotheundersideoftherefrigerantpipeswith
adhesivevinyltape.
2)Wraptherefrigerantpipesanddrainhosetogetherwithinsulation
tape.
Right-bottom
piping
Right-back piping
Bind coolant pipe
and drain hose
together with
insulating tape.
Remove pipe port cover
here for right-side piping.
Remove pipe port cover
here for right-bottom piping.
3)Passthedrainhoseandrefrigerantpipesthroughthewallhole,
thensettheindoorunitonthemountingplatehooksbyusingthe
markingsatthetopoftheindoorunitasaguide.
Mounting plate
A
4)Openthefrontpanel,thenopentheservicelid.
(Refertopreparationbeforeinstallation.)
5)Passtheinter-unitwirefromtheoutdoorunitthroughthe
feed-throughwallholeandthenthroughthebackoftheindoor
unit.Pullthemthroughthefrontside.Bendtheendsoftie
wiresupwardforeasierworkinadvance.(Iftheinter-unitwire
endsaretobestrippedrst,bundlewireendswithadhesive
tape.)
6)Pressthebottomframeoftheindoorunitwithbothhandsto
setitonthemountingplatehooks.Makesurethewiresdonot
catchontheedgeoftheindoorunit.
Wire guide
When stripping the
ends of inter-unit wire
in advance, bind right ends
of wires with insulating tape.
Hang indoor unit’s hook here.
Inter-unit wire
Mounting plate
A
01_EN_3P297034-1.indd 6 10/12/2011 11:37:02 AM

Other manuals for Daikin FTXS20K2V1B

Related product manuals