Daikin FTXS35LVMA - ON TIMER Operation

21
ON TIMER Operation
 To use ON TIMER operation
•Checkthattheclockiscorrect.
Ifnot,settheclocktothepresenttime.
Page10
1. Press .
“ ”isdisplayedontheLCD.
“
”blinks.
•“ ”anddayoftheweekdisappearfromtheLCD.
2. Press until the time setting reaches the
point you like.
•Eachpressingofeitherbuttonincreasesordecreasesthetimesettingby10minutes.
Holdingdowneitherbuttonchangesthesettingrapidly.
3. Press again.
•“ ”andsettingtimearedisplayedontheLCD.
•TheTIMERlamplightsyellow.
Display
 To cancel ON TIMER operation
Press .
•“ ”andsettingtimedisappearfromtheLCD.
•“
”anddayoftheweekaredisplayedontheLCD.
•TheTIMERlampgoeso󰀨.
 To combine ON TIMER and OFF TIMER
•Asamplesettingforcombiningthe2timersisshownbelow.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
NOTE
 In the following cases, set the timer again.
• Afterabreakerhasturnedo󰀨.
• Afterapowerfailure.
• Afterreplacingbatteriesintheremotecontroller.
01_EN_3P291209-1C.indd 21 31-Aug-20 6:29:49 PM