1
0
< In case of rear piping >
1. Open the holes on the rear panel. (Refer to Figure G).
2. Pass refrigerant pipes, drain pipes, and unit wiring through the hole on the rear panel.
< In case of downward piping >
1. Cut holes in the indicated area of the bottom frame. (Refer to Figure G).
2. Pass refrigerant pipes, drain pipes, and unit wiring through the hole on the bottom frame.
Figure G
Bottom panel
Insulation for fitting
Pipe retainer
Rear panel
Knock-out hole
Drain hose inside
the unit
Fix using the cable tie
Cut holes here
After rigging pipes and wiring, lock down the refrigerant pipes, drain hose inside the unit, indoor-out-door unit.
Transmission wiring and grounding line, in the piping guide.
1-IMOM-FS-FVFC-RZFC-DAIKIN-EN.indd 121-IMOM-FS-FVFC-RZFC-DAIKIN-EN.indd 12 5/14/2020 5:54:00 PM5/14/2020 5:54:00 PM
To Next Page
Loading...
