What to do if my Daikin FVXM25A2V1B Air Conditioner suddenly stops?
If your Daikin Air Conditioner suddenly stops operating, first check if the air inlet or outlet of the outdoor or indoor unit is not blocked by any obstacles. Remove any obstructions to ensure free airflow. The system might also halt temporarily due to voltage fluctuations, but it should automatically resume operation after approximately 3 minutes.
Why is my Daikin FVXM25A2V1B not cooling or heating enough even though air is blowing?
If your Daikin Air Conditioner operates but doesn't cool or heat sufficiently (air is blown from the unit), start by checking the air filters for clogs and clean them if necessary. Ensure that all doors and windows are closed to prevent drafts. Also, verify whether the unit is running in Econo mode and if furniture is obstructing the indoor unit; adjust as needed.
What to check if my Daikin FVXM25A2V1B Air Conditioner is not turning on?
If your Daikin Air Conditioner system does not operate at all, check for a power failure and wait until the power is restored. If the power failure occurred during operation, the system will automatically restart immediately after power is restored. Also, check if a fuse has blown or a breaker has been activated; replace the fuse or reset the breaker if needed. Lastly, check the batteries in the user interface.
Why is my Daikin FVXM25A2V1B not cooling or heating properly?
If your Daikin Air Conditioner operates, but cooling or heating is insufficient, check the airflow rate and temperature settings. Also, ensure the airflow direction is appropriate and that no obstacles block the air inlet or outlet of either the outdoor or indoor unit. Remove any obstructions to allow for free airflow.
Why is my Daikin FVXM25A2V1B Air Conditioner blowing no air but running?
If the Daikin Air Conditioner operates, but cooling or heating is insufficient and no air is blown from the unit, the air conditioner may be warming up for heating operation, so wait for 1 to 4 minutes. Alternatively, the unit may be in defrost operation.
What to do if my Daikin FVXM25A2V1B Air Conditioner remote display is blank?
If the user interface display of your Daikin Air Conditioner is blank, replace the batteries in the user interface.
Why is my Daikin FVXM25A2V1B not responding to the remote?
If the Daikin Air Conditioner unit does not receive signals from the user interface, check the batteries and ensure the transmitter is not exposed to direct sunlight. Also, check for electronic starter type fluorescent lamps in the room, and if the problem persists, contact your dealer.
Why does the Daikin app show a different temperature than my thermostat?
If the Daikin Residential Controller app displays a different indoor/outdoor temperature value than other appliances, note that the app shows the temperature specifically for the area around the indoor/outdoor unit. Variations can occur due to different environmental conditions such as direct sunlight or frost. The temperature displayed is for informational purposes only.
What to do if the Daikin Air Conditioner operation switch is not working?
If the operation switch on your Daikin Air Conditioner does not function properly, turn off the power supply.
General| Model | FVXM25A2V1B |
|---|---|
| Cooling Capacity | 2.5 kW |
| Heating Capacity | 3.2 kW |
| Refrigerant | R32 |
| Weight (Outdoor Unit) | 30 kg |
| Seasonal Energy Efficiency Ratio (SEER) | 6.10 |
| Power Supply | 220-240V/50Hz/1Ph |
| Dimensions (Outdoor Unit) | 550 x 765 x 285 mm |
To Next Page
