Installation EDUS39-900-F10
28 FXMQ-MF
Wiring Example And How To Set The Remote Controller
HOW TO CONNECT WIRINGS (Remove the electric parts box lid and wire as shown in the
figure below.)
Power supply wire, Ground wire (Refer to Fig. 17)
Connect the wire to L1 and L2 on the power supply terminal block (X1M). Also, connect the ground wire to the ground
terminal. Take the power supply wire and the ground wire into the unit through the wiring through hole <1>, and firmly
secure them together using the clamp (accessory 11)).
Transmission wire, Remote controller wire (Refer to Fig. 17)
Connect the transmission wire to F1 and F2 on the transmission terminal block (X2M). Connect the remote controller
wire to P1 and P2 on the transmission terminal block (X2M). Take them into the unit through the wiring through hole
<2>, and firmly secure the wires using the clamp (accessory 11)).
Wire the electrical components box so that the wiring is at least 3/8in. above the bottom of the electrical components
box.
Be sure to attach the sealing material or putty (field supplied) to the wiring through holes to prevent the infiltration of
water as well as any insects and other small creatures from outside. Otherwise a short-circuit may occur inside the
electrical components box.
Remote controller
wire
Transmission
terminal block (X2M)
Power supply
terminal block (X1M)
Power supply
wire
Ground wire
Electrical components
box lid
Fig. 16
Transmission
wire
Wiring
(Remote controller
and transmission)
Wire locking
bracket
Clamp
(accessory 11))
Conduit
(Field
supply)
Lock nut
(Field
supply)
L N
Electrical components box
X3M
A1P
X1M
X2M
Ground
terminal
Wiring
through
hole <1>
Wiring
through
hole <2>
Clamp
(accessory 11))
Clasp
Insulation tube
(accessory 2))
Fig. 17
To Next Page
Loading...
