English / 6
3. Install the Titanium apatite photocatalytic filter roll.
(1) Cut off one piece along the perforation.
(2) Place the dark colored surface facing up and then correctly
insert into the hooks (four) of the plasma ionizer.
• If the front surface and rear surface of the filer are mistaken, the per-
formance will drop.
(3) Store the remaining Titanium apatite photocatalytic filter roll in
the Titanium apatite photocatalytic filter roll receiver.
• The Titanium apatite photocatalytic filter roll can also be set without
being cut.
(1) Store the remaining Titanium apatite photocatalytic filter roll in
the Titanium apatite photocatalytic filter roll receiver.
(2) Correctly insert into the holes (four) of the Titanium apatite
photocatalytic filter roll into the hooks (four).
4. Install the plasma ionizer in its original configuration.
5. Mount the front panel to the main unit.
(1) Hang the hooks (two) at the top of the front panel on the
grooves of the top of the main unit.
(2) Hold the panel removal knobs (two locations, left and right) and
press into the main unit.
• If the front panel is not correctly set on the main unit, the unit will not
operate.
■
■■
■ Installation of main unit
Follow the standards below during installation.
〈
〈〈
〈
If installed on a table
〉
〉〉
〉
〈
〈〈
〈
If installed on a wall
〉
〉〉
〉
• Ask your dealer for a
wall-hanging kit (sold separately)
.
• If hanging the unit on a wall, make sure the wall is sufficiently strong
and has a pillar behind it.
• If operated outside the conditions shown below, malfunction may
occur.
• Indoor temperature 0 - 32 °C
• Indoor humidity 80% or less
Titanium apatite
photocatalytic filter roll
Hole
Hole
Hole
Hole
Hook
Hook (4 locations)
Dark colored
surface
Titanium apatite
photocatalytic
filter roll
Hole (4 locations)
Dark colored
surface
Titanium apatite
photocatalytic filter roll
Titanium apatite
photocatalytic
filter roll
Hole
Hook
Hook
(4 locations)
Hook
(2 locations)
Min. 100cm
Min. 50cm
Min. 50cm
Min. 10cm
To Next Page
Loading...
