Need help?Do you have a question about the Daikin RQ71KBV4A and is the answer not in the manual?
Steps to remove the propeller fan by unscrewing the discharge grille and fan setting nut.
Steps to disconnect the fan motor connector and remove the motor after loosening fixing bolts.
Steps to remove the mounting plate for the terminal block and electric component after disconnecting connectors.
Steps to remove connectors, a fixing screw, and then the PCB assembly from hooks.
Steps to remove the pressure sensor connector and cut brazing.
Steps to remove the lead wire and cut brazing to remove the pressure switch.
Steps to remove the coil and cut brazing to remove the electronic expansion valve body.
Procedure to remove the outdoor air thermistor by sliding it sideways.
Procedure to remove the discharge pipe thermistor by pulling out its mounting spring.
Procedure to remove the suction pipe thermistor by pushing its fixing part.
Procedure to remove the thermistor by pulling the clamp plate forward.
Procedure to remove the intermediate heat exchanger thermistor by pushing its fixing part.
Procedure to remove the liquid pipe thermistor by pushing its fixing part.
General| Model | RQ71KBV4A |
|---|---|
| Category | Heat Pump |
| Cooling Capacity | 7.1 kW |
| Heating Capacity | 8.0 kW |
| Power Supply | 220-240 V, 50 Hz |
| Refrigerant | R410A |
To Next Page