Why is my Daikin Air Conditioner not heating or cooling as expected?
Your Daikin Air Conditioner might not be heating or cooling as expected due to a few reasons. It could be due to incorrect connection of the electrical wires, in which case you should connect the electrical wires correctly. Another potential cause is gas leakage, so check for any gas leakage.
What to do if there's water leakage from my Daikin RXM71R2V1B?
If you notice water leakage from your Daikin Air Conditioner, it could be due to incomplete thermal insulation of the gas and liquid piping, or the indoor portions of the drain hose extension. Ensure the thermal insulation of the piping and the drain hose is complete. Another cause might be improperly connected drainage, so secure the drainage.
What to do if I suspect electrical leakage from my Daikin RXM71R2V1B?
If you suspect electrical leakage from your Daikin Air Conditioner, it's likely that the unit is not earthed correctly. Check and correct the connection of the earth wiring.
What to do if my Daikin Air Conditioner unit does not function or shows burn damage?
If your Daikin Air Conditioner unit does not function or shows burn damage, this may be because the wiring was not performed in accordance with the specifications. Correct the wiring.
General| Category | Air Conditioner |
|---|---|
| Type | Split System |
| Cooling Capacity | 7.1 kW |
| Heating Capacity | 8.0 kW |
| Refrigerant | R32 |
| Seasonal Energy Efficiency Ratio (SEER) | 6.1 |
| Indoor Unit Dimensions (H x W x D) | 295 x 990 x 263 mm |
| Power Supply | 220-240 V, 50 Hz |
Explains the various safety symbols and their meanings.
General safety instructions applicable to installers.
Safety precautions regarding the use and handling of R32 refrigerant.
Electrical safety precautions during installation and servicing.
Safety precautions for connecting refrigerant piping.
Safety instructions for electrical wiring and connections.
Steps for adding extra refrigerant to the system.
Overview of the process for connecting electrical wiring.
Step-by-step guide to connect wiring to the outdoor unit.
Safety measures to follow before and during troubleshooting.
Troubleshooting guide based on observed symptoms.
Diagnosing faults using the LEDs on the outdoor unit's circuit board.
To Next Page
