Daikin SiEN04-306D - Removal of the Electrical Box; PCB; Swing Motor

SiEN04-306D Indoor Unit
Removal Procedure 155
1.4 Removal of the Electrical Box / PCB / Swing Motor
Procedure Warning Be sure to wait 10 minutes or more after turning off all power supplies
before disassembling work.
Step
Procedure Points
1. Remove the front grille.
 Parts layout
2. Remove the drip proof
plate.
1
Loosen the screw.
3. Disconnect the indoor
heat exchanger thermistor
and the earth.
 Mind that not to lose the clip
for the thermistor.
Drip proof plate
(R2771)
Indoor heat exchanger thermistor
Earth
(R2772)