Daikin Sky Air Alpha RZAG100N2V1B - About the Box; Outdoor Unit; To Remove the Accessories from the Outdoor Unit; Preparation

3 About the box
Installation manual
10
RZAG71~140N2V1+Y1
Sky Air Alpha-series
4P695306-1 – 2022.05
3 About the box
3.1 Outdoor unit
3.1.1 To remove the accessories from the
outdoor unit
1×
1
2
3
ENERG
IJAY
IAIE
ENERG
IJAY
IAIE
1× 2×
b
1×
a c
1×
1×
d
e f
1×
a General safety precautions
b Outdoor unit installation manual
c Cable tie
d Fluorinated greenhouse gases label
e Energy label
f Addendum (LOT21)
4 Preparation
4.1 Preparing the installation site
WARNING
The appliance shall be stored in a room without
continuously operating ignition sources (example: open
flames, an operating gas appliance or an operating electric
heater).
4.1.1 Installation site requirements of the
outdoor unit
Mind the spacing guidelines. See the "Technical data" chapter, and
the figures on the inside of the front cover.
INFORMATION
The sound pressure level is less than 70dBA.
CAUTION
Appliance NOT accessible to the general public. Install it in
a secured area, protected from easy access.
This unit is suitable for installation in a commercial and
light industrial environment.
5 Installation
5.1 Mounting the outdoor unit
5.1.1 To provide the installation structure
Prepare 4 sets of anchor bolts, nuts and washers (field supply) as
follows:
(mm)
758
>150
(480-490)
485
4× M12
a
a Make sure not to cover the drain holes of the bottom
plate of the unit.
INFORMATION
The recommended height of the upper protruding part of
the bolts is 20mm.
20
NOTICE
Fix the outdoor unit to the foundation bolts using nuts with
resin washers (a). If the coating on the fastening area is
stripped off, the metal can rust easily.
a
5.1.2 To install the outdoor unit
4× M12
5.1.3 To provide drainage
INFORMATION
If necessary, you can use a drain pan (field supply) to
prevent drain water from dripping.