Need help?Do you have a question about the Daikin Sky Air Advance Series and is the answer not in the manual?
General| Brand | Daikin |
|---|---|
| Model | Sky Air Advance Series |
| Category | Air Conditioner |
| Language | English |
Explains danger, warning, caution, and notice symbols used in the manual.
General advice for installers and installation site requirements.
Safety for R32, installation space, and minimum floor area calculation.
Precautions for refrigerant leaks, recovery, charging, and compressor protection.
Safety precautions for brine, water, and electrical connections.
Information about the document's purpose, audience, and content.
Overview of the installer reference guide's chapters.
Instructions for unpacking, handling, and removing accessories/stays.
How to identify units and combine them with options.
What to do and know before going on-site for installation.
Requirements and considerations for the installation site.
Specific site requirements for cold weather installations.
Requirements and guidelines for refrigerant piping.
Details on piping material, diameter, length, and height differences.
Guidelines for insulating refrigerant piping.
Safety and procedures for preparing electrical wiring.
Typical workflow and stages of the installation process.
Procedures for opening indoor and outdoor units for access.
Steps for mounting the outdoor unit, including structure and drainage.
Measures to secure the unit against strong winds.
General precautions for connecting refrigerant piping.
Guidelines for bending pipes and connecting branch kits.
Procedures and precautions for brazing pipe ends.
How to handle stop valves and service ports.
Torque specifications for stop valves and service ports.
Procedure to remove pinched pipes from the system.
Steps to connect refrigerant piping to the outdoor unit.
Procedures and precautions for checking refrigerant piping for leaks.
Steps for performing vacuum drying to remove moisture.
Setup for checking refrigerant piping pressure.
Methods for leak detection and vacuum drying.
Guidelines for insulating refrigerant piping after leak test.
Procedures for charging additional refrigerant.
Steps for completely recharging the system with refrigerant.
Information about R32 refrigerant type and flammability.
Safety precautions when charging refrigerant.
Definitions of piping lengths and height differences.
How to determine and add refrigerant amount.
Examples of calculating additional refrigerant amounts.
Procedure to activate/deactivate vacuum mode for charging.
Typical workflow for connecting electrical wiring.
Compliance with regulations and wiring connection guidelines.
Specifications of standard wiring components.
Steps to connect electrical wiring to the outdoor unit.
How to route and fix cables, including knockout holes.
Steps to finish outdoor unit installation, including piping and cable management.
How to check the insulation resistance of the compressor.
What to do and know to commission the system after installation.
Safety and operational precautions before and during commissioning.
A checklist of items to verify before powering up the unit.
Steps to perform a test run to check unit operation.
Common error codes displayed during a test run and their causes.
Safety precautions for maintenance and service work.
Items to check during yearly maintenance of the outdoor unit.
Information for diagnosing and correcting problems.
Safety precautions to follow during troubleshooting.
Stages for disposing of the system.
Steps to pump down the system for disposal.
Information about service space, piping, and wiring diagrams.
Required clearance and spacing for outdoor unit installation.
Spacing requirements for multiple rows and stacked units.
Diagram showing the refrigerant piping layout.
Diagram showing the electrical wiring connections.
Guidance for consulting Eco Design data.
Definitions of technical terms used in the manual.
To Next Page
