3 | P a g e
2 ABOUT SAFETY
Transportation
• Transportation must be carried out in compliance with local laws and regulations.
• Lifting must be performed in accordance with the installation instructions in this
Manual. Manufacturer is not responsible for any equipment damage, personal
injury or death resulting from failing to comply with these requirements.
• The equipment must be lifted with the utmost attention and care. Avoid jolting
when lifting and lift the machine very slowly, keeping it perfectly level.
• It is prohibited to stay under the crane or equipment during lifting.
• Lifting should be performed by experienced personnel who is familiar with the
provisions of law and local regulations, and who has been properly trained or has
experience with this type of equipment.
• It is advisable to add some insulation material between lifting ropes and machine
to avoid scratching the equipment.
• The stability of the equipment during shipping must be ensured.
• Block equipment from sliding on lorries to prevent damage to the panels and base
frame. Avoid bumping, jolting and impacts during unloading and/or moving the
machine. Do not push or pull the equipment from any part other than the base frame.
Failure to follow above-mentioned instructions could cause serious damages for
which the manufacturer will not be held liable.
To Next Page
Loading...
