Before starting the installation of the unit, please read this manual carefully. Starting up the unit is
absolutely forbidden if all instructions contained in this manual are not clear.
Key to symbols
Failure to comply with this instruction may damage the machine or affect its operation.
Note concerning safety in general or compliance with laws and regulations.
Note concerning electrical safety.
Electric shock hazard can cause personal injury or equipment damage. This equipment must be
properly grounded. Connection to, and service of, the MicroTech III control panel must be performed
only by personnel who are knowledgeable in the operation of this equipment.
Static sensitive components. A static discharge while handling electronic circuit boards can cause
damage to the components. Discharge any static electrical charged by touching the bare metal inside
the control panel before performing any service work.
Never unplug any cables, circuit board terminal blocks, or power plugs while power is applied to the
panel.
To Next Page
Loading...
