7
(4) Remove the front panel and the service cover. (Refer to Fig. 5)
< How to remove the front panel and service cover >
(1) Open the front panel to the point where it stops.
(2)
Push the axes on either side of the front panel towards the center of the main unit and remove. (You can
also remove it by sliding the front panel either to the left or right and pulling it forward.)
(3)
Remove the screw from the service cover and pull the handle forward.
(5) Point the pipe in the direction it will be passed out.
For right, bottom-right, and back-right piping (Refer to Fig. 6)
•
Wrap the drain hose and the refrigerant piping together with the
finishing tape so that the drain hose is below the refrigerant piping.
For left, bottom-left, and left-back piping
• Remove the front grille. (Refer to Fig. 7)
< How to remove the front grille >
Remove the front grille as described below when securing the indoor
unit with screws or when attaching Optional Accessories (wireless
remote controller, adapter PC board, etc.).
(1) Remove the front panel.
(2) Remove the screws (3 places) securing the front grille.
(3) Remove the tabs (3 places) securing the front grille by pushing them in the direction of the arrows.
(4) Making sure not to catch the horizontal flaps, remove the front grille by pulling in the direction of the
arrow.
• Remove the drain plug, the insulation tubing, and the drain hose from the drain p
an and replace.
(Refer to Fig. 8)
• Connect the local refrigerant piping ahead of time, matching it to the liquid pipe and gas pipe marks
engraved on the installation panel (1).
Service cover
Axis
Axis
Axis
Fig. 5
Handle
Screw
Front panel
(1)
(2) (2)
(3)
Fig. 6
Tab position Tab position
Front grille
Fig. 7
Tab
(3) (3)
(4)
(3)
(2) (2)(2)
Screw position
Drain hose
Finishing Tape
(not included in accessories)
Refrigerant Piping
To Next Page
Loading...
