DAISHIN SRM180K Page 9
CONTROLS
TRAVEL LEVER
Push the lever forward to the handlebar, to make the machine moving. Release the lever, then the
machine stops.
SPEED LEVER
This lever allowed to change the travel speed from 1 (low speed) to 3 (high speed). Put the lever on
“R” to go on reverse. (1, figure 3). (N) position is neutral.
Always change travel speed when machine is stopped.
DIFFERENTIAL LOCKING LEAVER.
This lever allowed the rear wheels to be drived together in slipping area. The diff lock should be used
in straight line only, not when turning. (3, figure 2)
THROTTLELLVER AND CHOKELEVER
(4, figure 2)
Push the lever completely forward to operate the choke to start cold engine, when engine has start
release it. Push the throttle lever forward to « HI » to increase engine speed, pull the throttle lever
rearward to « LO » to decrease engine speed to idle rpm. Always operate mower at full engine speed.
Pull the throttle lever rearward to « STOP » to stop the engine
IMPORTANT
Do not use the choke when the engine is hot, it did not start
BRAKE LEVER
The brake lever is located on the right side of the handlebar. This lever is working with the travel lever.
When travel lever is released the brake is locked. Lock the lever when machine is stopped unatended
even in flat areas. (1, figure 5).
CUTTING BLADE CLUTCH LEVER
Cutting blade Clutch lever make the engine drive the blade to mow (2, Figure 2, ). Pull the lever
rearward to the handlebar to make the blade turning. Release the lever, then the blade stops.
Never try to start or stop the engine with blade engaged
To Next Page
Loading...