DAISHIN SRM180K Page 10
FUEL VALAVE
The fuel cock is closed when machine is not use.
Fuel cock is closed pushed rearward, and open
forward. (1, Figure 3)
Figure 3
HEIGHT OF CUT CONTROL
Height of cut can be setted by turning the bar A Figure 7, clockwise to increase the height of cut and
anti- clockwise decrease the height of cut.
Always perform this adjustment engine off and sparking
plug cover unplugWhen cutting in low position, power
needed and thrown objects are more important. Cutting
low can cause damage to the machine and injury.
Figure 4
To Next Page
Loading...