9
MAN# 650665:A
Programming
SETUP MENU
*To simplify the setup procedure, please download our IOS or Android app ‘Dakota Digital Motorcycle’*
The function switch is used to enter setup mode. To get into setup, press and hold the function switch while turning the
key on. Press and release the switch to advance through the menus below, press and hold to enter each menu.
Main Menu Sub Menu Description
BLUETOOTH STATUS CHECK Bluetooth ID and current connection status
OFF Disable Bluetooth connections
SETUP ONLY Allow Bluetooth connections only while in setup
ALWAYS ON Allow Bluetooth connections when key is on
LIGHTING COLOR COLOR THEMES Set factory defined color themes
SET ALL COLOR Set all areas to one color
DISPLAY COLOR Set speed digit color
LABEL COLOR Set speed label color
MESSAGE COLOR Set message location 1 and 2 color
BAR COLOR Set tach/fuel bar color
WARNING COLOR Set tach high warning color
DIMMING Set dimming method
SUNLIGHT Set sunlight brightness method
RESET Returns all colors and settings to factory default
SPEED ADJUST Adjust speed reading up or down while riding
AUTO Drive one mile (or km) to calibrate speed
UNIT Select MPH or km/h unit
SERVICE RESET Set miles to service reset value or turn off
ODO PRESET Odometer preset (Can only be set within the first 100 miles)
TACH INPUT Set cylinder count and input type
HIGH WARNING Set high RPM warning point
OIL PSI ON/OFF Enable/Disable option oil pressure reading
*If ON- The options below are only visible if this setting is set to on
LOW WARNING Set low warning point
TEST Display sender voltage for troubleshooting
OIL TEMP UNIT Select F or C for temperature unit
ON/OFF Enable/disable option oil temperature reading
*If ON- The options below are only visible if this setting is set to on
HIGH WARNING Set high warning point
TEST Display sender resistance for troubleshooting
VOLT LOW WARNING Set low warning point
DISPLAYS TOP MESSAGE Show/hide performance readings in Speed top message location
BTM MESSAGE Show/hide performance readings in Speed bottom message location
MBMS Show connected MBM’s and set warning points
GEAR PRESET Turn gear display off (factory reset)
LEARN Learn gears based on speed and RPM
FACTORY RESET Resets all settings except odometer to factory defaults
VERSION Displays software codes of each controller
EXIT SETUP Exit
To Next Page
Loading...
