1
MAN#650658:D
MLX-3012
3 3/8” direct plug-in instrument for:
2011- 2018 Softail Blackline & 2013-2017 Breakout
2012- 2017 Streetbob, Superglide, Lowrider and Wideglide
2014- up Sportster
2018- Fatbob Softail
Installation
The MLX-3012 is a direct replacement and uses the original housing, gaskets and screws.
1. On tank-mount models, begin by removing the dash. All models: remove the two screws on the back of the gauge
housing, then unplug the factory gauge, noting the position of the rubber gaskets; one on the front between the
gauge bezel and housing and (on handlebar-mount applications) one on the back between the housing and the
back plate.
2. Transfer the original gaskets to the MLX-3012, connect the factory plug and optional MBM harness if readings for
compass, boost or air pressure are desired. Route the MBM harness under the seat.
3. Securing with new gauge using the original screws.
Sportster mount installation
IMPORTANT NOTE!
This gauge has an odometer preset option that is only available for the first 100 miles (160km) of operation.
See “preset odometer” on page 6 for instructions.
Need help?
General
To Next Page