8
MAN#650658:D
FUEL Fuel level setup menu
A low warning will be displayed on either the fuel gauge or Speed Top as a red band warning when fuel reaches 10%.
• When “>FUEL” is displayed, press and hold the switch until “RELEASE”, then release the switch.
• The options to select between are “SENDER”, “RANGE TO EMPTY”, “TEST”, and “BACK”.
• Press and release the switch to change the selection, press and hold the switch to select it.
SENDER Fuel sender selection
• When “>SENDER” is displayed, then press and hold the switch until “RELEASE”, then release the switch.
• The options to select between are “SPORTSTER”, “DYNA”, “CUSTOM” and “BACK”.
• Press and release the switch to change to the proper sender.
• Press and hold the switch until “RELEASE”, then release the switch
• Exit fuel setup to confirm fuel selection
o CUSTOM is only for rare occasions if a stock sender is not being used.
o If CUSTOM is selected, you will be prompted to program.
o When “>PROGRAM” is displayed, press and hold until “RELEASE”, then release the switch.
o The display will show “SET EMPTY”
o With an empty tank, press and hold until “RELEASE”, then release the switch.
o The display will show “SET FULL”
o Fill the tank
o Press and hold until “RELEASE”, then release the switch.
o Exit setup to confirm fuel selection.
WARNING LIGHT Low fuel light setup
The low fuel indicator can be turned on or off
• When “>WARNING LIGHT” is displayed, then press and hold switch until “RELEASE”, then release the switch
• The options to select from are “OFF”, “ON”, and “BACK”
• Press and release the switch to change the option
• Press and hold the switch until “RELEASE” to save
RANGE TO EMPTY Distance to empty (fuel) setup
The range to empty option will calculate an estimate of miles until empty.
This will vary on riding conditions and will change as it continually monitors fuel usage and speeds.
The process will begin with a full tank, and then enter into the FUEL menu, RANGE TO EMPTY, and LEARN RESET.
Once the reset has been done, you may ride until the tank is below ¼.
This can be done over multiple trips as long as no fuel is added until the level is less than 25%, then it must be filled.
When the system is working, the DIST TO E screen will have a countdown odometer.
When the DIST TO E odometer reaches 35 miles or 56km, it show a “RANGE LOW” warning.
Once the RANGE TO EMPTY is working, you may fill your tank normally, when needed.
Range function not available on Sportster models as they have a low fuel switch and not an actual sensor.
• When “>RANGE TO EMPTY” is displayed, then press and hold the switch until “RELEASE”, and release the switch.
• The options to select are “ON”, “OFF”, and “BACK”.
• Press and release the switch to select an option.
• Press and hold the switch until “RELEASE”, then release the switch.
• If ON is selected, the next option is “LEARN RESET” and “BACK”.
• “LEARN RESET” will tell the gauge to learn fuel usage while riding. It can be reset again if the process failed.
o Once the fuel tank is full, you may select “LEARN PRESET”.
o Press and hold the switch until “RELEASE”, then release the switch.
o Exit setup
o Cycle the ignition then you may ride until fuel is less than 25%.
o Only then, you may refill the tank. Once full, the process will complete itself.
o Filling and refilling must be done the same way, either both on kick stand or both upright.
TEST Gauge reading test
• Press and release the switch until “TEST” is displayed, then press and hold the switch until “RELEASE” is displayed.
• The calculated fuel level from 0 – 99% will be shown. Press the switch to exit.
• Exit setup.
To Next Page
Loading...