Dakota Digital MLX-3012 - Page 9

9
MAN#650658:D
VOLT Low voltage warning setup
• When “>VOLT” is displayed, press and hold the switch until “RELEASE”, then release the switch.
• The low voltage warning points will range from 9.0 to 12.1 volts.
• Press and release the switch to change the low voltage warning point.
• Press and hold the switch until “RELEASE” is displayed, and release.
• Exit setup.
DISPLAYS Message display option menu
• When “>DISPLAYS” is displayed, press and hold the switch until “RELEASE” is displayed, and release.
• The display options are “MESSAGE TOP”, “MESSAGE BTM”, and “BACK”.
• The Speedometer has only two options: PERFOMANCE HIDE / SHOW.
o If “PERFORMANCE SHOW” is selected, the options of “HIGH SPEED RECALL”, “0-60 TIME”, “¼ MILE TIME, with ¼
MILE SPEED”, and “HIGH RPM RECALL” will be added to the display options available while riding.
o These options will appear after “SPEED km/h”, (or SPEED MPH if the speedometer is set to kilometers).
o Any MBM modules will automatically be added to the list in MESSAGE TOP and BTM
MESSAGE TOP Speed Top message screen information
• When “>MESSAGE TOP” is displayed press and hold until “RELEASE”, then release the switch.
• The options will be “PERFORMANCE HIDE”, “PERFORMANCE SHOW”, and “BACK”.
• Press and release to select the option.
• Press and hold the switch to select your preference.
MESSAGE BTM Speed Bottom message screen information
• When “>MESSAGE BTM” is displayed, then press and hold until “RELEASE”, then release the switch.
• The options will be “PERFORMANCE HIDE”, “PERFORMANCE SHOW”, and “BACK”.
• Press and release to select the option.
• Press and hold the switch to select your preference.
INDICATORS Select whether turn, high, oil, and neutral indicators are shown in display
These indicators will match the color of the SPEED LABEL area and will appear to each side of the label.
• When “>INDICATORS” is displayed, then press and hold until “RELEASE”, then release the switch.
• The options will be “HIDE”, “SHOW”, and “BACK”.
• Press and release to select the option.
• Press and hold the switch to select your preference.
MBMS Display which MBMs are connected and adjust warnings
To troubleshoot MBM connections, the speedometer can indicate which senders it sees connected.
• When “>MBMS” is displayed, press and hold until “RELEASE”, then release the switch.
• The screen will show “NONE” if there are no MBMs present.
• If MBMs are present you will see a list of the MBMs are connected.
• Press and release to scroll through the available MBMs that are connected.
• Press and hold the switch to enter warning setup (does not apply to all) for attached MBMs.
• Press and release the switch to scroll through available warning settings.
o See the separate MBM manual for additional details.
• Exit setup