8
ALARM CODES
CODE DESCRIPTION
SETTING DATA LOST, (LOADING FACTORY DEFAULTS)
PHASE FAULT
MAIN MOTOR OVERLOADED (RESET OVERLOAD SWITCH IN ELECTRIC BOX)
HIGH WORKING TEMPERATURE (SCREW TEMP. HIGHER THAN )
FOREWARNING HIGH TEMPERATURE (SCREW TEMP. HIGHER THAN ), WITH
AUTOMATICALLY RESET AS SOON AS THE TEMPERATURE DECREASES
-2°C
TEMPERATURE SENSOR IS DEFECTIVE
LOW TEMPERATURE (TEMPERATURE LOWER THAN )
LOW POWER SUPPLY
THE COMPRESSOR WILL NEVER STOP 1 HOUR FROM THE FRIST START; IT WILL RUN
LOAD/UPLOAD ACCORDING THE PRESSURE (WITHIN A 1 HOUR, REACHED SET VALUE.)
SECURITY PRESSURE SWITCH OPENED
PRESSURE OVER SET P03
PRESSURE TRANSDUCER / PRESSURE SWITCH FAILURE
EMERGENCY STOP BUTTON PUSHED
FOR RESETTING ALARMS PRESS
.
CHANGE AIR FILTER
CHANGE OIL FILTER
CHANGE SEPARATOR
CHANGE OIL
(FIXED) COMPRESSOR STOPPED / STAND-BY
(BLINKING) COMPRESSOR WAITING FOR STOP TIMER
To Next Page
Loading...