60 |
• The value shown on the display will stop flashing at the end of the boiler
heating phase. The machine is then ready for use.
NOTE
Carry out a unit washing cycle as explained in paragraph 6 when the ma-
chine is ready for use and BEFORE using it.
NOTE
The above mentioned heating enabling sequence occurs only when the ap-
pliance is switched on after a total switch-off by means of the main switch.
This sequence does not require too much energy in the heating phase of the
appliance thus avoiding problems of overloading the electrical system of the
place of installation.
3.1 Jug filling instructions (jug version)
1. Before filling the jug switch off the appliance and disconnect the plug from
the mains.
2. Never fill the water tank with hot, boiling or sparkling water to avoid da-
maging the tank and the appliance.
3. Lift the panel 12 fig.2 to access the jug compartment.
4. Remove the silicone tube from the jug.
5. Lift the jug and remove it from the machine.
6. Fill the tank using potable water as explained in punto 3.2 paying attention
not to exceed the limit indicated by the word MAX.
To Next Page
Loading...
