Serie "LXS9"
Page 4
WARNINGS/CAUTIONS
The appliance should be be started up by skilled service personnel ONLY.
All operations described in this manual, especially all maintenance operations concerning the electrical
part, should be carried out by skilled technical service personnel ONLY.
The vending machine is equipped with a safety switch that allows powering up all electrical parts only
when the door is closed. With this switch it is possible to power up the vending machine even with the
door open, for example to perform the test procedure on the vending motors. Be careful that all moving
parts (spirals, sliding anti-theft panel, etc.) are not accidentally activated.
This automatic vending machine is not intended for use by persons with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they are supervised or instructed on
the use of the vending machine by a person responsible for their safety. Children should be supervised
to make sure that they do not play with the vending machine.
Before checking any electrical part, move the main switch of the vending machine ( See Figure
2 ) to the “OFF” position.
UNPACKING
Unpack the vending machine as follows:
Cut the clear plastic wrapped around the packing box and remove the various protective corners.
Free the keys that are tied together with the power cord on the lower rear part of the vending machine.
To remove the wood supports, lift the vending machine using a suitable forklift truck ( with a lifting
capacity of at least 400 Kg and lifting height of 25 cm from the ground) and remove the metal brackets
blocking the vending machine‟s feet by removing the fixing screws.
ASSEMBLY OF BASE PLATE (COVERING FEET)
There is a large package containing the base plate of the vending machine, inside the machine,
between the door display window and the product drawers.
Remove the base plate from its packaging and position it under the door in front of the feet, pressing
against the base of the vending machine.
The base plate will remain fixed to the base thanks to the magnetic hooks it comes with.
To Next Page
Loading...
Need help?
General
