Damp2Dry PACD150 - Troubleshooting

-11-
Please check the following troubleshooting tips before
calling for assistance.
NOTE: If you have tried the above troubleshooting and need additional
assistance, contact Consumer Services at 877-365-6274.
PROBLEM CAUSE SOLUTION
Dehumidier
does not operate
No power to appliance. Connect plug to power
outlet.
Power not turned on. Switch power on.
E4 error is displayed. Check drainage ow.
Dehumidier
collects little/no
water
Insufcient working time Allow more working time
Filter is blocked Clean lter
Low ambient
temperature
Increase ambient
temperature
Condensate hose is
blocked
Check hose for
restrictions
Difference between set
humidity and current
actual humidity is
minimal
Adjust humidity setting to
a lesser setting
Humidity is too low for
the unit to run.
No need to run the unit.
Dehumidier
is operating
but room is not
drying
Doors and windows are
open
Seal room from external
areas by closing doors,
windows, etc.
TROUBLESHOOTING